รายละเอียดสินค้า
Uses
- Outdoor flooring
- Car park
- External of pipeline
- Bridge
- Harbour infrastructure
Features
- Cost-effective.
- Rapid curing. The whole process normally takes within a second, excessively reduce the construction time.
- High elasticity.
- High wear resistance.
- High chemical resistance.
- Seamless.
- Excellent impact resistance. Tough, high mechanical strength.
Technical & Physical Data
Instruction for Use
1.Surface Preparation:
All the surfaces must be clean, free from grease, oil, laitance, and remove all the dirt and contaminants, which might affect adhesion. The impurity outside the structure body should be cleaned thoroughly. Any crack or water leakage area should be pre-treated and reinforced.
2.Primer:
Based on the on-site inspection by Cireco sales personnel, it is recommended to use PU, Epoxy, acrylic primer, or similar materials as the base coat.
3.Application:
For the application of this material, it is necessary to use a heatable, pressurized, two-liquid type spraying equipment. Because of the relatively high viscosity and fast reaction characteristics of this material, the spray pressure is adjusted to at least 1600–2000psi to ensure complete mixing.
Due to its 100% solids and fast curing characteristics, the thickness of the spray is not limited, but in order to ensure the quality of the work, it is recommended to spray at least twice to reach the design thickness. 1mm/1.1kg/m2、2mm/2.2kg/m2、3mm/3.3kg/m2
4.Curing:
For optimum performance, Cireco Uri 2500 should be allowed to cure for 12 hours before the finishing concrete, tiles etc. During this period of (at least) 12 hours of curing, precautions must be taken to avoid damage to the coating.
5.Clean:
Curing material can be cleaned by machine.
Health & Safety
Wash both hands after work. Ensure adequate ventilation when using these products. If working in confined areas, suitable respiratory protective equipment must be used. Wear protective gloves when handling these products. The selected protective gloves must comply with the standard of EN374 or equivalent.
Eye protection should be worn. Safety glasses for side shields must be comply with EN166, ANSI 87.1-2010 or equivalent. Wear suitable protective clothing. Types of protective clothing or equipment must be selected according to the amount and concentration of hazardous materials in a specific workplace.
If contact with skin occurs, it must be removed before curing takes place. Wash off with an industrial skin cleanser followed by plenty of soap and water. Do not use solvent. In case of contact with eyes, rinse thoroughly with plenty of water and seek medical advice if symptoms persist.