- Car park
- Outdoor flooring
- Harbour infrastructure
- Internal of chemical container
- Rapid curing.
- High wear resistance.
- High chemical resistance.
- Tough, high mechanical strength.
- Excellent impact resistance.
- High elasticity, Slip and skid resistance.
- Resistant to most of the industrial chemical product.
- Very high bonding strength to the properly handled construction surface.
- The whole process normally takes within a second, excessively reduce the construction time.
Technical & Physical Data
Instruction for Use
All the surfaces must be clean, free from grease, oil, laitance, and remove all the dirt and contaminants, which might affect adhesion. The impurity outside the structure body should be cleaned thoroughly. Any crack or water leakage area should be pre-treated and reinforced.
For the application of this material, it is necessary to use a heatable, pressurized, two-liquid type spraying equipment. Because of the relatively high viscosity and fast reaction characteristics of this material, the spray pressure is adjusted to at least 1800–2500 psi (126–175 kg/cm2) to ensure complete mixing.
Due to its 100% solids and fast curing characteristics, the thickness of the spray is not limited, but in order to ensure the quality of the work, it is recommended to spray at least twice to reach the design thickness. 1mm/1.1kg/m2、2mm/2.2kg/m2、3mm/3.3kg/m2
For optimum performance, Cireco SioUrea 6000 should be allowed to cure for 12 hours before the finishing concrete, tiles etc. During this period of (at least) 12 hours of curing, precautions must be taken to avoid damage to the coating.
- Note: When spraying, the surrounding environment and decorative surface materials must be properly protected to avoid adhesion of sprayed materials.
Curing material can be cleaned by machine.
Health & Safety
Wash both hands after work. Ensure adequate ventilation when using these products. If working in confined areas, suitable respiratory protective equipment must be used. Wear protective gloves when handling these products. The selected protective gloves must comply with the standard of EN374 or equivalent.
Eye protection should be worn. Safety glasses for side shields must be comply with EN166, ANSI 87.1-2010 or equivalent. Wear suitable protective clothing. Types of protective clothing or equipment must be selected according to the amount and concentration of hazardous materials in a specific workplace.
If contact with skin occurs, it must be removed before curing takes place. Wash off with an industrial skin cleanser followed by plenty of soap and water. Do not use solvent. In case of contact with eyes, rinse thoroughly with plenty of water and seek medical advice if symptoms persist.